ProCurve 530 Manuel d'utilisateur télécharger pdf (Page 10)

Reset to factory default can be done by keeping the reset key pressed for 5-10 seconds. After the reset, you can

Username: admin

Password:

HP ProCurve Access Point 420#

Country configuration. For some older software versions sk must be used (some channels were inaccessible for

cz).

HP ProCurve Access Point 420#country cz

Reboot system now to make the country code change effective? : y

Reboot system...

Basic AP setting:

• Setting the password for the admin account.

• Enabling SSH.

• Remote logging and SNTP server

HP ProCurve Access Point 420#configure

Enter configuration commands, one per line.

HP ProCurve Access Point 420(config)#management

Enter management commands, one per line.

HP ProCurve Access Point 420(config-mgmt)#password-admin

HP ProCurve Access Point 420(config-mgmt)#ip ssh enable

HP ProCurve Access Point 420(config-mgmt)#end

ProCurve Access Point 530(config)# logging 10.229.255.15

ProCurve Access Point 530(config)# sntp 10.229.255.15

Enabling VLAN:

HP ProCurve Access Point 420(config)#vlan enable static

Reboot system now? : y

Configuring the interface management and assigning to VLAN:

HP ProCurve Access Point 420#config

HP ProCurve Access Point 420(config)#interface ethernet

HP ProCurve Access Point 420(if-ethernet)#no ip dhcp

HP ProCurve Access Point 420(if-ethernet)#ip address 10.229.255.61 255.255.255.0

10.229.255.1

HP ProCurve Access Point 420(if-ethernet)#end

HP ProCurve Access Point 420(config)#management-vlanid 504 tagged

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

ProCurve 530 Manuel d'utilisateur Page 10