ProCurve 2610-PWR Informations techniques télécharger pdf (Page 123)

100

101

Spanning-Tree Operation

Configuring Rapid Reconfiguration Spanning Tree (RSTP)

Figure 5-4. Example of the Spanning Tree Configuration Display

Enabling or Disabling RSTP. Issuing the command to enable spanning

tree on the switch implements, by default, the RSTP version of spanning tree

for all physical ports on the switch. Disabling spanning tree removes protec-

tion against redundant network paths.

Syntax: [no] spanning-tree

Abbreviation: [no] span

This command enables spanning tree with the current parameter settings or

disables spanning tree, using the “no” option, without losing the most-recently

configured parameter settings.

Enabling STP Instead of RSTP. If you decide, for whatever reason, that

you would prefer to run the IEEE 802.1D (STP) version of spanning tree, then

issue the following command:

Syntax: spanning-tree protocol-version stp

Abbreviation: span prot stp

For the STP version of spanning tree, the rest of the information in this section

does not apply. Refer to “802.1D Spanning-Tree Protocol (STP)” on page 5-23

for more information on the STP version and its parameters.

5-15

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 363 364

Commentaires sur ces manuels

Pas de commentaire

ProCurve 2610-PWR Informations techniques Page 123

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel ProCurve 2610-PWR