ProCurve 2610-PWR Informations techniques télécharger pdf (Page 283)

IP Routing Features

Configuring IRDP

[ minadvertinterval < seconds > ]

This parameter specifies the minimum amount of time the

routing switch can wait between sending Router

Advertisements. Default: three-fourths (0.75) the value of the

maxadvertinterval parameter.

If you change the maxadvertinterval parameter, the software

automatically adjusts the minadvertinterval parameter to be

three-fourths the new value of the maxadvertinterval

parameter. If you want to override the automatically

configured value, you can specify an interval from 1 to the

current value of the maxadvertinterval parameter.

[preference < number >]

This parameter specifies the IRDP preference level of this

routing switch. If a host receives Router Advertisements from

multiple routers, the host selects the router interface that sent

the message with the highest preference as the host's default

gateway. The valid range is -4294967296 to 4294967295.

Default: 0.

Displaying IRDP Information

To display IRDP information, enter the following command from any CLI level:

ProCurve# show ip irdp

Status and Counters - ICMP Router Discovery Protocol

Global Status : Disabled

VLAN Name Status Advertising Min int Max int Holdtime Preference

Address (sec) (sec) (sec)

-------------- -------- ------------ ------- ------- -------- -----------

DEFAULT_VLAN Enabled multicast 450 600 1800 0

VLAN20 Enabled multicast 450 600 1800 0

VLAN30 Enabled multicast 450 600 1800 0

Figure 7-9. Example of Displaying IRDP Information

7-25

1 2 ... 278 279 280 281 282 283 284 285 286 287 288 ... 363 364

Pas de commentaire

ProCurve 2610-PWR Informations techniques Page 283