ProCurve 2610-PWR Informations techniques télécharger pdf (Page 277)

12-19

Port Trunking

Port Status and Configuration

LACP Notes and Restrictions

802.1X (Port-Based Access Control) Configured on a Port. To main-

tain security, LACP is not allowed on ports configured for 802.1X authentica-

tor operation. If you configure port security on a port on which LACP (active

or passive) is configured, the switch removes the LACP configuration, displays

a notice that LACP is disabled on the port(s), and enables 802.1X on that port.

The switch will not allow you to configure LACP on a port on which port

access (802.1X) is enabled. For example:

To restore LACP to the port, you must first remove the port’s 802.1X configu-

ration and then re-enable LACP active or passive on the port.

Port Security Configured on a Port. To maintain security, LACP is not

allowed on ports configured for port security. If you configure port security

on a port on which LACP (active or passive) is configured, the switch removes

the LACP configuration, displays a notice that LACP is disabled on the port(s),

and enables port security on that port. For example:

The switch will not allow you to configure LACP on a port on which port

security is enabled. For example:

LACP Partner Yes: LACP is enabled on both ends of the link.

No: LACP is enabled on the switch, but either LACP is not enabled or the link has not been detected on

the opposite device.

LACP Status Success: LACP is enabled on the port, detects and synchronizes with a device on the other end of the

link, and can move traffic across the link.

Failure: LACP is enabled on a port and detects a device on the other end of the link, but is not able to

synchronize with this device, and therefore not able to send LACP packets across the link. This can be

caused, for example, by an intervening device on the link (such as a hub), a bad hardware connection,

or if the LACP operation on the opposite device does not comply with the IEEE 802.3ad standard.

Status Name Meaning

ProCurve(config)# aaa port-access authenticator e b1

LACP has been disabled on 802.1X port(s).

ProCurve(config)# int b1 lacp passive

Error configuring port < port-number >: LACP and 802.1X cannot be run

together.

ProCurve(config)# port-security a17 learn-mode static address-limit 2

LACP has been disabled on secured port(s).

1 2 ... 272 273 274 275 276 277 278 279 280 281 282 ... 468 469

Pas de commentaire

ProCurve 2610-PWR Informations techniques Page 277