ProCurve 2610-PWR Informations techniques télécharger pdf (Page 349)

100

101

A-9

File Transfers

Downloading Switch Software

The SCP/SFTP Process

To use SCP and SFTP:

1. Open an SSH session as you normally would to establish a secure

encrypted tunnel between your computer and the switch. For more

detailed directions on how to open an SSH session see the chapter titled

“Configuring Secure Shell (SSH)” in the Access Security Guide for your

switch. Please note that this is a one-time procedure for new switches or

connections. If you have already done it once you should not need to do

it a second time.

2. To enable secure file transfer on the switch (once you have an SSH session

established between the switch and your computer), open a terminal

window and type in the following command:

ProCurve(config)# ip ssh filetransfer

Command Options

If you need to enable SSH v2 (which is required for SFTP) enter this command:

ProCurve(config)# ip ssh version 2

Note As a matter of policy, administrators should not enable the SSHv1-only or the

SSHv1-or-v2 advertisement modes. SSHv1 is supported on only some legacy

switches (such as the ProCurve Series 2500 switches).

To confirm that SSH is enabled type in the command

ProCurve(config)# show ip ssh

3. Once you have confirmed that you have enabled an SSH session (with the

show ip ssh command) you can then open your third-party software client

application to begin using the SCP or SFTP commands to safely transfer

files or issue commands to the switch.

If you need to disable secure file transfer:

ProCurve(config)# no ip ssh filetransfer

1 2 ... 344 345 346 347 348 349 350 351 352 353 354 ... 468 469

Commentaires sur ces manuels

Pas de commentaire

ProCurve 2610-PWR Informations techniques Page 349

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel ProCurve 2610-PWR