ProCurve 2610-PWR Informations techniques télécharger pdf (Page 344)

ProCurve Stack Management

Configuring Stack Management

For example, if the ProCurve 8000M in the above listing did not have a Manager

password and you wanted to make it a stack Member with an

SN of 2, you

would execute the following command:

ProCurve(config)# stack member 2 mac-address 0060b0-

dfla00

The show stack view command then lists the Member added by the above

command:

SN (Switch Number) 2 is the

new Member added by the

stack member

command.

The new member did not have a System Name

configured prior to joining the stack, and so receives a

System Name composed of the stack name (assigned in

the Commander) with its SN number as a suffix.

Figure 8-30. Example Showing the Stack After Adding a New Member

Using Auto Join on a Candidate. In the default configuration, a Candi-

date’s Auto Join parameter is set to “Yes”, meaning that it will automatically

join a stack if the stack’s Commander detects the Candidate and the Com-

mander’s Auto Grab parameter is set to “Yes”. You can disable Auto Join on a

Candidate if you want to prevent automatic joining in this case. There is also

the instance where a Candidate’s Auto Join is disabled, for example, when a

Commander leaves a stack and its members automatically return to Candidate

status, or if you manually remove a Member from a stack. In this case, you

may want to reset Auto Join to “Yes”.

Status: [no] stack auto-join

ProCurve(config)# no stack auto-join

Disables Auto Join on a Candidate.

ProCurve(config)# stack auto-join

Enables Auto Join on a Candidate.

8-38

1 2 ... 339 340 341 342 343 344 345 346 347 348 349 ... 363 364

Pas de commentaire

ProCurve 2610-PWR Informations techniques Page 344