ProCurve 2610-PWR Informations techniques télécharger pdf (Page 97)

Multimedia Traffic Control with IP Multicast (IGMP)

How IGMP Operates

Supported Standards and RFCs

ProCurve’s implementation of IGMP supports the following standards and

operating capabilities:

• RFC2236 (IGMP V.2, with backwards support for IGMP V.1)

• IETF draft for IGMP and MLD snooping switches (for IGMP V1,

V2 V3)

• Full IGMPv2 support as well as full support for IGMPv1 Joins.

• Ability to operate in IGMPv2 Querier mode on VLANs with an IP

address.

The ProCurve implementation is subject to the following restrictions:

• Interoperability with RFC3376 (IGMPv3)

• Interoperability with IGMPv3 Joins. When the switch receives an

IGMPv3 Join, it accepts the host request and begins forwarding

the IGMP traffic. This means ports that have not joined the group

and are not connected to routers or the IGMP Querier will not

receive the group's multicast traffic.

• No support for the IGMPv3 “Exclude Source” or “Include Source”

options in the Join Reports. Rather, the group is simply joined

from all sources.

• No support for becoming a version 3 Querier. The switch will

become a version 2 Querier in the absence of any other Querier

on the network.

Note IGMP is supported in the HP MIB, rather than the standard IGMP MIBs, as the

latter reduce Group Membership detail in switched environments.

Operation With or Without IP Addressing

You can configure IGMP on VLANs that do not have IP addressing. The benefit

of IGMP without IP addressing is a reduction in the number of IP addresses

you have to use and configure. This can be significant in a network with a large

number of VLANs. The limitation on IGMP without IP addressing is that the

switch cannot become Querier on any VLANs for which it has no IP address—

so the network administrator must ensure that another IGMP device will act

as Querier. It is also advisable to have an additional IGMP device available as

a backup Querier. See the following table.

4-13

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 363 364

Pas de commentaire

ProCurve 2610-PWR Informations techniques Page 97